Precautions for installing equipment in fruit and vegetable cold storage:
1. Walk in chiller room installation unit
It is better to install the cold storage unit as close as possible to the evaporator, so that the cold storage unit can dissipate heat better and facilitate inspection and maintenance. When installing the cold storage unit, the unit must be installed with anti-vibration gaskets. The unit must be installed firmly and kept level. The unit installation is best not to be easily touched by people. The cold storage unit must be installed in a location that must be able to shade and protect from rain.
2. Unit condenser
The installation position of the radiator of the cold storage unit is considered to dissipate heat for the cold storage unit, so the radiator of the cold storage unit should be installed as close as possible to the unit, and it is best to be installed above the unit. The installation position of the radiator of the unit should have the best heat dissipation environment, and the air suction port should deviate from the air outlet of other equipment in the cold storage, especially some oily gas outlets must not face each other; the air outlet of the radiator should not be short distance away or face other windows or other places. equipment. When installing, there must be a certain distance from the ground, about 2m high from the ground, and the installation must be kept level and firm.
3. Refrigeration system connection
When installing the cold storage, the condenser and evaporator of the cold storage equipment unit are packaged and sealed in the factory, so there is pressure when opening and changing the packaging. Open it and check for leaks. The two ends of the copper pipe Whether dust measures have been taken to prevent dust or water from entering the pipeline. The refrigeration system connection is generally installed in the order of condenser; cold storage host; evaporator. When welding copper pipes, the welding joint must be firm and beautiful.
4. Wire discharge
Electricity is necessary for the operation of the cold storage, so the wires of the cold storage are also many and complicated. Therefore, the discharge of the wires should be tied up with cable ties, and the corrugated hoses or wire troughs should be used for protection. Key points: it is best not to discharge the wires close to the wires in the fresh-keeping cold storage, so as not to affect the temperature display data.
5. Copper pipe discharge
When installing and placing copper pipes in the cold storage, try to follow a straight line and fix them tightly at intervals. Copper pipes must be wrapped with insulation pipes and wires in the same direction with cable ties.
Post time: Aug-05-2023